Field Repairs Far From a Shop: Tubeless Plugs, Chain Links, Broken Spokes and the Bodges That Get You Home

The repairs that matter on a tour are not the ones in the workshop manual. They are the ones done in the rain, at dusk, forty kilometres from the nearest village, with the tools that fit in a frame bag. We have broken most of the things a bike can break, and what follows is the short list of failures that actually happen, the repairs that work, and the bodges we have used when the proper part was at home. None of this replaces a well-maintained bike; all of it has saved a trip.

The kit that earns its place

Our repair kit weighs about 600 g and has not changed much in years. A multitool with hex keys from 2 to 8 mm, a T25 driver and a chain breaker. A tubeless plug tool with a dozen plugs of two sizes. Two tyre levers, a pump that can reach 4 bar and seat a bead, a spare tube even on a tubeless bike, and a patch kit with vulcanising glue. Two quick links for the chain. A spare derailleur hanger for the frame. Three spare spokes of the right lengths taped to the chainstay, with nipples. A small spoke key, a few zip ties, a metre of duct tape wrapped around the pump, a short length of strong cord, and a small tube of grease. A tyre boot cut from an old tyre sidewall. Spare brake pads for anything over a week.

What we leave at home matters as much: no cassette tools, no bottom bracket tools, no spare cables on a hydraulic bike. If those fail, a bus is the repair.

Tubeless punctures

Most small holes seal on their own if you keep riding for a minute and let the sealant work, ideally with the hole at the bottom of the wheel. Holes that keep spraying need a plug. The technique is to leave the tyre on the rim, find the hole, push the plug in with the tool until only about a centimetre remains outside, twist a quarter turn and pull the tool out cleanly. Pump to pressure and ride; the sealant bonds the plug in a few kilometres. Trim the tail later.

Cuts longer than about 8 mm will not hold a plug. For those, the tube goes in. Break the bead, pull out the valve, wipe out the sealant, place a boot inside the tyre over the cut, fit the tube, and inflate. Duct tape folded double works as a boot in a pinch, as does a folded banknote. Check the inside of the tyre for the thorn or glass first, every time. Fitting a tube around the same thorn twice is a rite of passage nobody needs.

A tyre that will not seat tubeless with a mini pump usually needs more air volume, not more effort. Remove the valve core, pump hard and fast, and re-fit the core once the bead pops. If it still refuses, the tube is the answer and the sealant can wait for a compressor.

Chains

A chain that snaps on a climb is almost always a stiff link or a worn chain finally giving up, and the repair is the chain breaker. Push out the damaged link pair, join the two ends with a quick link, and the chain is two links shorter, which is fine on all but the biggest sprockets. Avoid the largest cog until the chain is replaced. Carry two quick links; the first one ends up in the grass.

If the rear derailleur is the thing that broke, which on rough ground it often is, the bodge is to shorten the chain further and run the bike as a singlespeed. Pick a middle sprocket, remove the derailleur or zip-tie it out of the way, size the chain with the wheel pulled back in the dropout if it is a horizontal one, and ride gently. With vertical dropouts the chain will be slightly slack and will skip under power, so climb sitting down and spin. It has carried us 60 km to a town.

Spokes and wheels

A broken spoke on the rear wheel, usually on the drive side under a loaded bike, is the field repair that intimidates most people, and it need not. First, wrap the broken spoke around its neighbour or remove it so it cannot flail. Then open the rim brake if you have one, or accept some rubbing on a disc bike. Loosen the two spokes either side of the break by a quarter turn each, and tighten the two on the opposite side of the rim by the same. Spin the wheel, check the wobble, repeat until it clears the frame. This will get you to the next town.

Fitting a spare spoke properly on the drive side requires removing the cassette, which is why we do not carry the tool: instead, we carry an emergency spoke made of flexible cable with a hook at each end, which threads through the hub flange without removing anything, and tensions with a normal nipple. It stays in for as long as needed. If the rim itself is cracked, the game is over; ride slowly and stop if it gets worse.

The bodge list

  • Bent derailleur hanger: straighten by hand or with the hex key in the derailleur bolt as a lever, then fit the spare hanger at camp.
  • Split tyre sidewall: boot inside, tube in, ride at low pressure, replace the tyre at the next shop.
  • Broken rack strut: hose clamp or zip ties over a tent peg or a spoon handle as a splint. It will hold for days.
  • Lost bolt: steal one from a bottle cage. A cage with two bolts survives on one.
  • Failed seatpost clamp: wrap the post with a strip cut from an old tube and re-clamp; the rubber adds friction.
  • Stripped cleat bolt: tape the shoe to the pedal or ride the other side of the pedal; flat shoes for the rest of the day.
  • Torn bag or strap: dental floss and a sewing needle for cloth, zip ties for buckles, duct tape for everything else.

Prevention, which is most of it

The honest truth is that nearly every field repair we have done could have been avoided by a check before leaving. Chains wear out predictably: a cheap gauge reads the stretch, and a chain replaced at 0.5 percent wear saves the cassette and rarely snaps. A wheel that has lost a spoke is a wheel that was under-tensioned, so a proper true and tension before a long trip is money well spent. Sealant dries out; check it. Brake pads wear faster on wet gravel than anywhere else; look at them at every rest day. Bolts on racks, cages and cleats loosen with vibration; a quick pass with the multitool on the first evening finds them before the road does.

And practise. Plug a tyre at home. Break and rejoin a chain in the kitchen. True a wheel in the frame with the spoke key you will carry. The repairs are all simple, but not the first time, and the first time should not be on a mountain road with the light going.

Read next: What Is a Gravel Bike, and Is It the Right Bike for Bikepacking?